Car throwing codes and misfiring - FirebirdV6.com/CamaroV6.com Message Board

Announcement

Collapse
No announcement yet.

Car throwing codes and misfiring

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Car throwing codes and misfiring

    So my car is throwing codes : P0305 (misfire cylinder 5) P1362 and P136?? I just changed out the ICM also yest. Any ideas where to start with those last two codes?

  • #2
    Re: Car throwing codes and misfiring

    Might want to have the actual coil packs and plug wires checked out.
    Stephen<br />1995 Pontiac Firebird<br />3800 Series II V6<br /><br />2000 Pontiac Firebird Formula

    Comment


    • #3
      Re: Car throwing codes and misfiring

      could the icm be bad?

      Comment


      • #4
        Re: Car throwing codes and misfiring

        i would test the coils, plugs & wires
        Wait, Is that a V6 or V8?
        1990 Chevrolet C-K 1500 series 4.3L .. 5spd
        1994 JDM Euno Roadster 1.8L 5spd Bolt Ons.. etc
        2000 Camaro 3.8L Auto Bolt Ons..etc

        Comment


        • #5
          Re: Car throwing codes and misfiring

          Originally posted by ACiFiC View Post
          i would test the coils, plugs & wires
          X2 would test them, if neg. the test your injectors.
          08' L76 6.0L 4X4 Chevy EXT.Cab LTZ Vortec MAX with Snug top cover, Dynomax exhaust,Hptuners& K&N intake
          96' Camaro M5 to A4 conversion, alot of mods . GT35R Turbo full suspension. Built engine

          Comment


          • #6
            Re: Car throwing codes and misfiring

            Why did you change out the ICM - was that before the codes?
            96 White M5 Camaro. Manual everything. Magnaflow cat, dynomax dual outlet axle back. Swapped to a disc rear with 3.42s and a torsen differential, kyb gr2 rear shocks, moog rear endlinks.

            Comment


            • #7
              Re: Car throwing codes and misfiring

              yes the icm replacement was before, the main reason why is because one of the coils looked bad (metal exposed) and the bolt holding it was rounded off so i ended up destroying the old icm getting it off so i replaced it along with the coil. If the coil was bad wouldnt it cause multiple misfires? but will check it all tomorrow finally get a chance to work on it. This misfire comes back every month just jumped cylinder. Even when i think ive fixed it its still there when i press the gas hard but runs fine if i drive normally. I dont get why

              Comment

              Latest Topics

              Collapse

              There are no results that meet this criteria.

              FORUM SPONSORS

              Collapse
              Working...
              X