So my car is throwing codes : P0305 (misfire cylinder 5) P1362 and P136?? I just changed out the ICM also yest. Any ideas where to start with those last two codes?
Announcement
Collapse
No announcement yet.
Car throwing codes and misfiring
Collapse
X
-
Re: Car throwing codes and misfiring
i would test the coils, plugs & wiresWait, Is that a V6 or V8?
1990 Chevrolet C-K 1500 series 4.3L .. 5spd
1994 JDM Euno Roadster 1.8L 5spd Bolt Ons.. etc
2000 Camaro 3.8L Auto Bolt Ons..etc
Comment
-
Re: Car throwing codes and misfiring
Originally posted by ACiFiC View Posti would test the coils, plugs & wires08' L76 6.0L 4X4 Chevy EXT.Cab LTZ Vortec MAX with Snug top cover, Dynomax exhaust,Hptuners& K&N intake
96' Camaro M5 to A4 conversion, alot of mods . GT35R Turbo full suspension. Built engine
Comment
-
Re: Car throwing codes and misfiring
Why did you change out the ICM - was that before the codes?96 White M5 Camaro. Manual everything. Magnaflow cat, dynomax dual outlet axle back. Swapped to a disc rear with 3.42s and a torsen differential, kyb gr2 rear shocks, moog rear endlinks.
Comment
-
Re: Car throwing codes and misfiring
yes the icm replacement was before, the main reason why is because one of the coils looked bad (metal exposed) and the bolt holding it was rounded off so i ended up destroying the old icm getting it off so i replaced it along with the coil. If the coil was bad wouldnt it cause multiple misfires? but will check it all tomorrow finally get a chance to work on it. This misfire comes back every month just jumped cylinder. Even when i think ive fixed it its still there when i press the gas hard but runs fine if i drive normally. I dont get why
Comment
Comment