Welcome to the FirebirdV6.com/CamaroV6.com forums.
You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
If you have any problems with the registration process or your account login, please contact contact us.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
That makes sense. I have not replaced the regulator yet but it's worth a shot to see if that's the problem before changing the pump. I tested it again this afternoon after sitting all night and the results were exactly the same as yesterday. 40psi the entire time, no matter what the state of the engine. So I'll change up the regulator and go from there!
thanks guys, I seriously appreciate the help.
1997 30th Anniversary Camaro.
SLP CAI, Dynomax, PCM tune, SS Hood, Clear Corners, T-Tops, Sony Xplod
Don't just change the regulator- pull the vacuum line off as they describe in the video and look for fuel. If it doesn't leak fuel and is good, no sense in wasting money to replace it. Better off putting that money towards another mod on the car
Right, ha ha I'll check it first! I have the stuff to give the coil packs, plugs and wires a refresh, so while I'm in there doing all that, I might just change it out anyway to save from having to do it again down the road without everything out. That thing is 20 years old, I'm sure its wearing out...just like my fuel pump too!
1997 30th Anniversary Camaro.
SLP CAI, Dynomax, PCM tune, SS Hood, Clear Corners, T-Tops, Sony Xplod
You guys know if anyone has ever installed a permanent fuel pressure gauge to our schrader valve under the hood? Saw one like this: http://www.mtiracing.com/media/catal...45e0539bd1.jpg for the LS1's but that one clearly has a lot of room, where ours does not. Just curious. Figured since I'm going to be needing a gauge a lot while I figure out this issue, might not hurt to install something to always be keeping an eye on it.
1997 30th Anniversary Camaro.
SLP CAI, Dynomax, PCM tune, SS Hood, Clear Corners, T-Tops, Sony Xplod
I'd say if you're going to get one, get one that displays in the cab off of a gauge, not in the engine bay like that. That only lets you see idle and if you rev it up in park- won't let you see anything while driving or at WOT.
also the regulator is easy to access on the fuel rail so no point in freshening it up now if it is working. Test it, and try to eliminate it from the problem. If it goes down the road it is a 15 minute job
I had a Autometer fuel pressure gauge comes with the sender and gauge so you dont have gas in the cab. Worked good. Thats the only way to do it in my opinion.
08' L76 6.0L 4X4 Chevy EXT.Cab LTZ Vortec MAX with Snug top cover, Dynomax exhaust,Hptuners& K&N intake
96' Camaro M5 to A4 conversion, alot of mods . GT35R Turbo full suspension. Built engine
Alright, took the vacuum line off the FPR and not a single trace of fuel could be found over several minutes so I think we're good there. Looks like 1 of 2 things is happening. Either the fuel pump is slowly going and I'm stuck with intermittent usage OR the fuel filter was clogged and after it was replaced it's back up and running. But that filter was really new.
I'm leaning towards the pump might be on its last leg. I'll give it credit, it fires up right away both over the weekend and tonight but it still just hangs around 40-41psi for pressure, even at high RPM. I'm going to install the cab mounted pressure gauge so I can take it out for a short drive and see how it does under load next.
1997 30th Anniversary Camaro.
SLP CAI, Dynomax, PCM tune, SS Hood, Clear Corners, T-Tops, Sony Xplod
You can get electronic ones that you have a sensor on the shrader and then hooked up to a gauge inside.
But don't worry about that for now - prop it up and tape it to your windshield and go for a drive so you can see it. It should be 48-52 psi key on engine off and while driving if it isn't the pump is bad assuming you just said you have ruled out the FPR.
youre more patient than me, id have just said screw it, cut the panel and replaced the pump first and went from there. for shits and giggles sake... have you checked the pump harness plug where it connects on the body? its drivers side, you'll see 2 plugs in front of the rear tire. should be the left plug. pull it and make sure theres no crap in there causing a bad connection. if its dirty hit it with a wire brush to clean the connections and plug it in. had it happen to me
current car- 95 Trans am- bolt ons, parked and collecting dust. why? because **** it
I did not check there! I will make sure to check it out next time I'm under there. I did change out the fuel filter that the SOB fired up and has been running ever since, although I haven't been driving it around either. So the fuel filter must have been clogged, which is odd since it was less than 6 months old at the time it went out. My mechanic said that it is possible that the fuel filter is coming apart and could be clogging the filter. So I think either way the pump is going to be changed out this winter. Just to be safe. Dont want to get to the track and have it crap out on me again.
1997 30th Anniversary Camaro.
SLP CAI, Dynomax, PCM tune, SS Hood, Clear Corners, T-Tops, Sony Xplod
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment