Here is some help to anyone that might have this issue. the vertical guide for my drivers side window had a problem. the metal head on the roller worked out of the hole in the metal plate riveted to the window. the whole was too big now to put it back in.
easy fix.
I drilled into the metal head on the roller with a small size bit. Then I tapped a 6-32 into the metal head thingy. Went to the hardware store, bought a 6-32 1/2 inch bolt and a washer, put the metal head thingy of the roller back into the hole, used the bolt and washer to secure it from comming back out. You dont have to use the 6-32 size, you could do a little bigger if you would like. [img]smile.gif[/img]
Works great! just thought I'd share this with anyone that had this problem. Window/door shops charge like 75 bucks and more to do a 10 minute 99 cent job.
easy fix.
I drilled into the metal head on the roller with a small size bit. Then I tapped a 6-32 into the metal head thingy. Went to the hardware store, bought a 6-32 1/2 inch bolt and a washer, put the metal head thingy of the roller back into the hole, used the bolt and washer to secure it from comming back out. You dont have to use the 6-32 size, you could do a little bigger if you would like. [img]smile.gif[/img]
Works great! just thought I'd share this with anyone that had this problem. Window/door shops charge like 75 bucks and more to do a 10 minute 99 cent job.
Comment