Tweet
do you have to reuse that off white housing or can i wire tie the pump to the bracket? and if i dont use the housing what do i do with the two rubber lines that are for the feed line and the vent that goes on the housing, the two rubber hoses that attach to the housing, what do i do with them if i dont reuse the housing? will i have problems if i just wire tie the walbro to the bracket rather than reusing the housing? i cant get the old pump out it wont pull apart, would it hurt if i just let those other two rubber hoses hanging since the housing isnt there?
-
Longtubes, true duals, ram air, caspers tps tec, ls1 26lb injectors, supersix powerpack, heads milled .020, comp cam .507 220/224 114 ls, forged internals and chromeoly pushrods, bored .030 over, tb spacer, tranny built with stiffer springs and kevlar bands, bigger servo, transgo stage 3 shift kit, edge 3600 stall, 1 pc aluminum ds, 3.73 superior gears, lsd rear ,custom pcm tuning, walbro 255 in tank,
-
I’m new. I actually don’t own a Camaro or firebird. I do have a 2000 Camaro 3.8 fly by throttle and 4l60e. This is installed in a 1980 Triumph TR7...1 week ago -
Not much going on, replaced my Kenwood double din stereo with a Pioneer double din, the Kenwood had problems. Then replaced my power inverter for my reverse...1 week ago -
Hi all new to the community here. I have a 2014 RS 6 speed manual... and so about a year ago my tail lights got cracked and eventually the plastic housing...3 weeks ago
