Tweet
where is it located?
for a 3.4 camaro
for a 3.4 camaro
-
-
UNDER VEHICLE, DRIVER SIDE, BELOW SEATING AREA, FRONT OF REAR WHEELWELL, MOUNTED ON CHASSIS IN FUEL LINE.
Not shouting, this was copied from a file.- Josh<br />If you have any questions or need installation pics/help, e-mail me: Viper98885@aol.com<br /><a href=\"http://Camaroz28.cardomain.com/id/viper98885\" target=\"_blank\">\'93 Camaro Hardtop</a><br /><a href=\"http://Camaroz28.cardomain.com/id/01lincolnls8\" target=\"_blank\">\'01 Lincoln LS8 Sport</a><br />\'00 Yamaha YZF-R6<br /><a href=\"http://www.ftpp.net\" target=\"_blank\">Full Throttle Performance</a> -
well today I went to change it but the damn bolt is so rusty I could not get it off :mad: can someone tell me which way does the bolt come off?toward the passenger side?Comment
-
lefty loosey ..righty tighty!!! Also look into some good lubricant with anti rust properties and put some on the bolt..then try.Originally posted by BiH:
well today I went to change it but the damn bolt is so rusty I could not get it off :mad: can someone tell me which way does the bolt come off?toward the passenger side?Comment
-
If that doesn't work, use vice grips and don't screw up the thing too bad.- Josh<br />If you have any questions or need installation pics/help, e-mail me: Viper98885@aol.com<br /><a href=\"http://Camaroz28.cardomain.com/id/viper98885\" target=\"_blank\">\'93 Camaro Hardtop</a><br /><a href=\"http://Camaroz28.cardomain.com/id/01lincolnls8\" target=\"_blank\">\'01 Lincoln LS8 Sport</a><br />\'00 Yamaha YZF-R6<br /><a href=\"http://www.ftpp.net\" target=\"_blank\">Full Throttle Performance</a>Comment
-
before you screw up the lines go and pick up a set of line wrenches...1996 Silver camaro Z28. M6,<br />12 bolt, 4.11\'s, posi, Rear cover, Spec stage 2, loudmouth, more <a href=\"http://home.mainstreamtopics.com/?index=3&module=1\" target=\"_blank\">http://home.mainstreamtopics.com/?index=3&module=1</a> <Mods, Pics & more <a href=\"http://home.mainstreamtopics.com/?index=3&module=2\" target=\"_blank\">http://home.mainstreamtopics.com/?index=3&module=2</a> <Fbody Tech ArticalsComment
-
had to remove the fuel line and then take the filter off.well I got it offComment
-
did you cut the lines? I'm confused1996 Silver camaro Z28. M6,<br />12 bolt, 4.11\'s, posi, Rear cover, Spec stage 2, loudmouth, more <a href=\"http://home.mainstreamtopics.com/?index=3&module=1\" target=\"_blank\">http://home.mainstreamtopics.com/?index=3&module=1</a> <Mods, Pics & more <a href=\"http://home.mainstreamtopics.com/?index=3&module=2\" target=\"_blank\">http://home.mainstreamtopics.com/?index=3&module=2</a> <Fbody Tech ArticalsComment
-
And dont forget to relive your fuel pressure before you get started , you dont need to be breathing in all that gas while its pouring out of the line . [img]smile.gif[/img]98 silver camaro t-tops , loaded<br />NGK plugs , Taylor 8mm wires , Optima Red Top .Comment
-
where would the filter be located on a 3.8? And how do you relieve the fuel pressure in the lines?1996 Pontiac Firebird<br />Flowmaster Exhaust, Custom Cold Air Intake, 3.42 gears with LSDComment
-
Same place. All you have to do is take your gas cap off and the pressure is released. Don't think for a second that you won't still leak gas though (it's a slow drip).\'99 SSM Camaro V6 M5<br />(mod list on cardomain site; too long to list here)<br /> <a href=\"http://www.cardomain.com/id/v6cam99\" target=\"_blank\">http://www.cardomain.com/id/v6cam99</a>Comment
-
Had to be evacuated Monday again after a fire was going on the hill behind us. Only 3-4 hours, they did a good job getting it under control. Especially...1 week ago -
Up for sale is my 2001 Chevrolet Camaro 3.8 in need of some TLC and help. I’ve owned this vehicle the past 18 years (since 2006) and it’s been very...3 weeks ago
Comment