manual fan

[Warlock]

Tomorrow Im installing my 160 degree thermostat and wiring manual fan switch in. I was just wondering what gauge of wire should i use for the manual fan switch dont want to burn the wire up from to much current.

[V6MaroFL]

I used 22 and have had no problem. It doesn't have to be large, you can use 18 if you're worried about it.

[v6camaroloser]

im not much of an electrician, but when i made mine, i used the prettiest wire i could find at the cheapest price. no clue what gauge it is. i don't think alot of current goes through it to b honest. i've had no problems either though. and it always makes people think i've got some top secret supercharger if i turn the fans on 2 seconds b4 i start the engine or leave them on 2 seconds after i cut it [img]graemlins/evilgrin.gif[/img]

[Warlock]

Hey thanks u think i well make so difference at the track. Last time i was running hot as u can tell by my timeslip be low.

[V6MaroFL]

It will cool off your engine and a cooler engine should run a bit better. Let us know how you do. [img]smile.gif[/img]

[TurboKillaZ]

like they said your engine will be cooler and will run better

[Jason McCallister]

From the schematics I've seen posted online, there's not much current flowing through the wires since it only powers a relay. ;)