Tweet
I just installed a jet stage 2 chip into my 98 m5 camaro. When i start the car the car idles around 2000 rpm for around 10 seconds then drops back down to normal idle. Also if im driving and put the car into neutral, my rpms drop below 500 and one time the car actually stalled
-
Mods:<br />Whisper lid, free ram air, high flow cat, 3\" catback, flowmaster 80 series, 160* thermo, Jet stage II, 18\" Breyton rims on 245 kuhmos -
I cant understand what the problem with it is. Any info would be helpful.
ThanksMods:<br />Whisper lid, free ram air, high flow cat, 3\" catback, flowmaster 80 series, 160* thermo, Jet stage II, 18\" Breyton rims on 245 kuhmos -
did you install it properlyComment
-
Pretty sure i did. Does anyone have any install instructions for this?Mods:<br />Whisper lid, free ram air, high flow cat, 3\" catback, flowmaster 80 series, 160* thermo, Jet stage II, 18\" Breyton rims on 245 kuhmosComment
-
i had this problem too, and for me it was becasue i didnt screw the chip in its place correctly, either too much or too little torque. try that, and make surethe little needles are lined up right, and none of them are bent when you put it back in. good luck.daveComment
-
Thanks i'll have to give that a tryMods:<br />Whisper lid, free ram air, high flow cat, 3\" catback, flowmaster 80 series, 160* thermo, Jet stage II, 18\" Breyton rims on 245 kuhmosComment
-
Had to be evacuated Monday again after a fire was going on the hill behind us. Only 3-4 hours, they did a good job getting it under control. Especially...1 week ago -
Up for sale is my 2001 Chevrolet Camaro 3.8 in need of some TLC and help. I’ve owned this vehicle the past 18 years (since 2006) and it’s been very...3 weeks ago -
So went out to start the Camaro and no start, batteries are good just hear a thud sound, started up fine last Friday. Check the fuses and the battery...4 weeks ago
Comment