Jet chip problems. Please help - FirebirdV6.com/CamaroV6.com Message Board

Announcement

Collapse
No announcement yet.

Jet chip problems. Please help

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Jet chip problems. Please help

    I just installed a jet stage 2 chip into my 98 m5 camaro. When i start the car the car idles around 2000 rpm for around 10 seconds then drops back down to normal idle. Also if im driving and put the car into neutral, my rpms drop below 500 and one time the car actually stalled
    Mods:<br />Whisper lid, free ram air, high flow cat, 3\" catback, flowmaster 80 series, 160* thermo, Jet stage II, 18\" Breyton rims on 245 kuhmos

  • #2
    I cant understand what the problem with it is. Any info would be helpful.
    Thanks
    Mods:<br />Whisper lid, free ram air, high flow cat, 3\" catback, flowmaster 80 series, 160* thermo, Jet stage II, 18\" Breyton rims on 245 kuhmos

    Comment


    • #3
      did you install it properly

      Comment


      • #4
        Pretty sure i did. Does anyone have any install instructions for this?
        Mods:<br />Whisper lid, free ram air, high flow cat, 3\" catback, flowmaster 80 series, 160* thermo, Jet stage II, 18\" Breyton rims on 245 kuhmos

        Comment


        • #5
          i had this problem too, and for me it was becasue i didnt screw the chip in its place correctly, either too much or too little torque. try that, and make surethe little needles are lined up right, and none of them are bent when you put it back in. good luck.
          dave

          Comment


          • #6
            Thanks i'll have to give that a try
            Mods:<br />Whisper lid, free ram air, high flow cat, 3\" catback, flowmaster 80 series, 160* thermo, Jet stage II, 18\" Breyton rims on 245 kuhmos

            Comment

            Latest Topics

            Collapse

            FORUM SPONSORS

            Collapse
            Working...
            X