I'm not sure where this topic would fall, but its a general post so I put it here. Anyway after 3 runs on a dynojet I had almost consistant hp and torque. My max for each out of the 3 runs was 166hp and 225 foot pounds of torque. And only with the mods listed below. So I'm sorta dissappointed, but its not too bad. Just think if I had an ATI procharger under there though *cough, BATMAN cough* [img]smile.gif[/img]
Announcement
Collapse
No announcement yet.
3 dyno runs
Collapse
X
-
Thats not terrible, I pushed 175hp and 225ftlbs with my 2000 A4 and I had basically what you have only I had a flowmaster bolted onto the stock I pipe [img]smile.gif[/img]2002 5-spd NBM Camaro
Details: www.1lev6.com
-
what would help me reach 200hp? I know an exhaust would help, I'm a little hesitant with that because I want 3" pipe from headers back... and of course thats alot of money. Besides nitrous and forced air, what else would be some pretty inexpensive things. College students have to keep that mod budget low :/
Comment
Latest Topics
Collapse
-
by ssms5411Had to be evacuated Monday again after a fire was going on the hill behind us. Only 3-4 hours, they did a good job getting it under control. Especially...1 week ago
-
by RPDRed6Up for sale is my 2001 Chevrolet Camaro 3.8 in need of some TLC and help. I’ve owned this vehicle the past 18 years (since 2006) and it’s been very...3 weeks ago
-
by ssms5411So went out to start the Camaro and no start, batteries are good just hear a thud sound, started up fine last Friday. Check the fuses and the battery...4 weeks ago
Comment