Who has gone 3.4 to 3.8 swap (nay sayers stay out)

[speedracer95v6]

Came with everything but the last 2 02 sensor connectors.

You say it works fine without them though? does it run any different cause if not ill just disable my SES light and offroad pipe it from my Y to my catback with no sims.

[speedracer95v6]

Oh yeah, no cut wires...just didnt come with that last part connected. Everything else is there(very curious....).

[3.4 slow to go]

About the tranny question. This should clear all quaetions once & for all.

v6 60* 700-4R tranny bolt pattern = V6 60* 4L60/E bolt pattern.

V6 60* 4L60/e bolt pattern = 3800 Series II 4L60E bolt pattern.

want to see some proof? He's reusing the origonal tranny from the carbed 2.8.

You can even see teh TV cable on the pass side beside the throttle cable.

[ November 23, 2003: Message edited by: 3.4 slow to go ]</p>

[RedFrk13]

<blockquote>quote:</font><hr>Originally posted by speedracer95v6:
Came with everything but the last 2 02 sensor connectors.

You say it works fine without them though? does it run any different cause if not ill just disable my SES light and offroad pipe it from my Y to my catback with no sims.<hr></blockquote>

I cant tell u if it runs any different because i never ran it set up correctly. It runs fine with only the front two connected. I dont mind the SES light, because i have autotap and check the codes every once in a while just to make sure nothing new is wrong.