Tweet
air/fuel gauge problems
ok this is unusual my air fuel gauge stoped reading or would read very lean and little to no switching. was throughing codes for bank 1 snsr1 no activity, insuficant switching and bank 1 too lean, replaced O2 twice no change. car runing very rich. pulled O2 bank 1 covered in black stuff cleaned and asitched with bank 2 sensor did not hook up air/fuel gauge car ran great full switching on snap-on scanner hooked up gauge bank 1 stoped switching only reading .019 to 100mV un hook gauge back to normal. it seemes the a/f gauge was grounding the signal. has any one else had this problem? power and ground to gauge are good. and gauge is about 21/2 years old
- Welcome to the FirebirdV6.com/CamaroV6.com forums.
You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
If you have any problems with the registration process or your account login, please contact contact us. - If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
