Tweet
P0113 Intake Air Temperature (IAT) sensor circuit high voltage ok so what do I do about it. And I got a P01404 I don’t know what it is.
-
-
Re: Throwing codes
check your IAT sensor and make sure the wires are not cut or broken loose. Also make sure the sensor is into the intake good and nothing is obstructing airflow over it -
Re: Throwing codes
only advise is to just look at the sensor to see if it is damaged, look at the wiring really good and try to follow it as far as it goes and look for damage. if you see nothing out of the ordinary, replace it. I need my tech 2 hooked up to really diagnose that bad boy
and if you didn't know, this is the IAT Sensor
no such thingOriginally posted by 3800Y87Last edited by BLLDOGG; 01-31-2007, 05:42 PM.Comment
-
Re: Throwing codes
So y would it give me a code that doesnt exist. Ur say the code reader was wrong?Comment
-
Re: Throwing codes
DTC P1404 Exhaust Gas Recirculation (EGR) Closed Position Performance
closest i could find
current car- 95 Trans am- bolt ons, parked and collecting dust. why? because **** it
Follow me!
http://www.twitch.tv/optimusprymrib
Or thisComment
-
I’m new. I actually don’t own a Camaro or firebird. I do have a 2000 Camaro 3.8 fly by throttle and 4l60e. This is installed in a 1980 Triumph TR7...1 week ago -
Not much going on, replaced my Kenwood double din stereo with a Pioneer double din, the Kenwood had problems. Then replaced my power inverter for my reverse...2 weeks ago -
Hi all new to the community here. I have a 2014 RS 6 speed manual... and so about a year ago my tail lights got cracked and eventually the plastic housing...4 weeks ago
Comment