Welcome to the FirebirdV6.com/CamaroV6.com forums.
You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
If you have any problems with the registration process or your account login, please contact contact us.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
It has been a year since mine has been off, but I do believe you will have a small bolt to remove that holds the electrical connector to that. Not the spark plug wire, but the actual wire harness attached to the back of the piece that all the coil packs mount onto.
Dont be so confident that it is in the coil pack I've the same issue with my car for nearly a year runs good then devops a miss at higher rpms pops and misses, weakand then gets better change plugs gets better ..for a while I've changed coil packs the board they sit on plugs, wires and still have the same problem as long as I run premium gas its not as bad
Check your MAF sensor, mine caused all kinds of problems, the code it threw out indicated the MAF sensor, not a misfire so eventually once it was fixed it ran smooth but it decided to throw a misfire code about a day after when it was clearly not misfiring so I just reset the PCM and have been code free since... I dont understand the computer too well but it seems to have a mind of its own
also make sure your plug wires are NOT resting on the manifold! I actually had the shop that put in my reman. engine do that...
As for the bolt, You could dremel into it like they said, or dremel the sides down like I do. Make one side flat, then on the completely opposite side, dremelt it down flat, that way a good pair of vice grips, an adjustable wrench or a pair or pliers will go onto the bolt no problem.
Haven’t done anything on the Camaro, but put LEDs on my truck headlights . And my oil pressure sensor went out on the truck so going to fix that this...
Haven’t done anything on the Camaro, but put LEDs on my truck headlights . And my oil pressure sensor went out on the truck so going to fix that this...
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment