SES light

[cmartin99]

well, i crank my car up and its running horridly at low rpms, so i give it a slight rev.. i can tell it has hardley any power, then the SES light blinks at me, i cut it off, cut it back on, same thing... i drive it home anyways, since i dotn like camping out in parking lots... and it blinks at me bassically the whole way home, i can feel the power loss, and it's still shaking.. any suggestions on the problem.. i've already replaced the 3-6 coil pack, so i know it could be the module or another c-p goin bad...

[Chris Camaro]

change plugs and wires, is it only at low rpms?

[cmartin99]

well, the shaking is more noticable at low RPM's.. and the wire adn plugs are a good 3 months old

[cmartin99]

went to auto zone, cylinder 3 misfire... when we replaced the last coil pack (free) the guy who changed said if it went bad then it was probably the module.. so i'll probably be replacing it module and coil packs with MSD products... is this what i should do? or not worry about it and get stock ones... or, get stock module with accel coil packs... i'm wanting to get out of this as cheap as possible... but if it's not incredibly more to do MSD or the Accel route i will do that

[ August 11, 2005, 05:23 PM: Message edited by: cmartin99 ]