turn signal

[99firebird]

hey guys. my turn signal wont work,i replaced the bulbs and the lights work up front but when i turn on the signal it stays on solid , what can be the problem.....

[99firebird]

also the last time i replaced the bulbs i forgot to put the elect. greese and the sockets a little burned on the inside.... could that be the problem... like i said though the lights still work when i put in the new bulbs.

[99W68Firebird]

should work even if dont put grease on it.. but maybe its the rear lights?

[magic1872]

put in backwards or wrong bulb....Does it have 2 filiments

[tdaddyz]

your flasher has prolly went bad buy a new one from autzone for like $2. it's under the dash

[ianwells100]

Originally posted by tdaddyz:
your flasher has prolly went bad buy a new one from autzone for like $2. it's under the dash

[99firebird]

where under the dash is the flasher, and how hard is it to install?

[Leaf52382]

if it's solid then one of your flasher lights went out.. change the front or the back one... when they are good it will flash again on your dash board

[3495 Blackbird]

Change the bulbs for the rear lights also. Each bulb has two filaments. So even though they light up, one filament is probably burnt out, so the turn signals won't work.