Tweet
I just used my OBDII scanner on my 2000 Camaro and it stated that there is a Cylinder 3 Misfire detected. How do I fix this, and how much will it cost? I also just had my plugs and wires changed.
-
Last edited by tbonebuggs; 08-02-2007, 04:55 PM. -
Re: Problem code P0303?
Check to see if that wire isn't touching your exhaust.<a href=\"http://www.fbodyelpaso.org\" target=\"_blank\">www.fbodyelpaso.org</a> A4 stock 3.42 and LSD not Y87,SLP cold air induction, whisper lid, k&n filter, flowmaster 80 series, hypertech, 160 powerstat thermostat, t/a front bumper, functional nostrils, pacesetter headers best et: 15.9 at about 4800ft -
Re: Problem code P0303?
Which wire?Comment
-
Re: Problem code P0303?
the number 3 wire. Or you couyld swap number 3 with another and see if problem follows. Wire could have been damaged on the install, or you could have a coil going bad, or maybe even the ICMOriginally posted by kala
TEAM BLACK!!!
parting her outComment
-
Had to be evacuated Monday again after a fire was going on the hill behind us. Only 3-4 hours, they did a good job getting it under control. Especially...1 week ago -
Up for sale is my 2001 Chevrolet Camaro 3.8 in need of some TLC and help. I’ve owned this vehicle the past 18 years (since 2006) and it’s been very...3 weeks ago -
So went out to start the Camaro and no start, batteries are good just hear a thud sound, started up fine last Friday. Check the fuses and the battery...4 weeks ago
Comment