Tweet
I'm doing it tomorrow. Any tips? What size Torx do I need? And how are the butt parts attached to the floor??
-
-
The butt peices are easy. They each have a single bolt holding them in place, it's under the front part of each seat in the center. Remove the bolt and the seat will lift off.
As for the top part, I don't remember the size of the torx bit. I have a universal set that attaches to a 3/8" drive, and I let one of my friends borrow the set about 2 weeks ago. As soon as I get it back, I'll post it for you if you still need it.
-Marc
[ February 12, 2003: Message edited by: hockeyman ]</p>sigpic -
Thank you!! [img]smile.gif[/img]Comment
-
I used a T50 to get the large hardware out, but found it easier to just use very strong vice grips.<a href=\"http://www.onid.orst.edu/~waltejam/\" target=\"_blank\">98 Bright Red Camaro</a><br />Too many mods to list....check my websiteComment
-
I’m new. I actually don’t own a Camaro or firebird. I do have a 2000 Camaro 3.8 fly by throttle and 4l60e. This is installed in a 1980 Triumph TR7...1 week ago -
Not much going on, replaced my Kenwood double din stereo with a Pioneer double din, the Kenwood had problems. Then replaced my power inverter for my reverse...1 week ago -
Hi all new to the community here. I have a 2014 RS 6 speed manual... and so about a year ago my tail lights got cracked and eventually the plastic housing...3 weeks ago
Comment