Homemade Cold Air (IAT Location?)

[V8 Killer]

Well,I bought 3 inch PVC Pipe and a K&N Cone...I can mount it pretty good but what do I do with the IAT? Can i just drill a hole somewhere between the filter and throttle body and stick the IAT in there and seal it up with silicon or something?

[hockeyman]

Yes, it's mountable basically anywhere before the Throttle Body.

[V8 Killer]

Would silicon sealant be ok? No sensor damage or anything?

[hockeyman]

Silicone should be fine to use. Of course, let it dry before installing the iat sensor.

[Need4Camaro]

I just drilled it into the rubber boot before the TB and it works fine for me...

[c-wood bird]

Yep, any of those will work, but you could also put a 15Kohm resister into the plug. It won't give you much more power but it won't throw any codes either. If you'd like more info do a search, I think most people call it the "resistor mod".

[ June 08, 2005, 06:59 PM: Message edited by: c-wood bird ]

[c-wood bird]

http://www.camarov6.com/cgi-bin/ulti...=002786#000001
Here's a post on it.

[grayman]

you can also use a large fat grommet. perfect fit is a late model v8 fbody IAT grommet.