3.4 Camaro Dual Exhaust

[Pmpn]

I am going to be putting dual exhaust of my 95 3.4 camaro and I want to know which muffler to go with. I was looking at the rear section dual exhaust kit from rksport.com but I figured I could get it all done cheaper if I bought the muffler and had it custom put on. I am also going to go with 3" outlet tips. post some links of which mufflers would sound the deepest. I was looking around the board and people were saying like flowmaster 40 and 80 series or would a borla muffler be better sounding. I would like to keep it all under $275 including the custom pipe bending from the shop.

[ June 01, 2003: Message edited by: Pmpn ]</p>

[SixBanger]

Don't buy that crap from RKSport! Just get an 80 series flowmaster and put your own pipes and tips on it. You will be pleased with the end results.

[Pmpn]

what is the model number of the 80 series muffler? and where is the cheapest place to find it?

[ June 02, 2003: Message edited by: Pmpn ]</p>

[Pmpn]

how much would a shop charge to weld the muffler on and run 2 pipes out of it and weld some tips on? and wheres a good place to find 2 chrome 3" tips

[Predator Bird]

if you want to get a borla rear section, you could always get this. http://cgi.ebay.com/ebaymotors/ws/eB...category=33630 then just buy a set of nice tips and have a shop put it on.

[fbird]

when i had my flowmaster put on, and had the tail pipe welded on it cost me about $50-$60(can't really remember)

[SixBanger]

you can find the 80 series on summitracing.com

Be sure to get the one 2.5 inlet/2.5 outlet.

[Pmpn]

i just ordered the borla muffler