Tweet
just out of curiosity mainly(was wondering at work today) if i were to go with a 98+ front end conversion then would i also be able to add the lid type intake like 98+ cars or would i be stuck with the pre97 intake setup?
-
Black 97 Camaro T-Tops<br />3800 series II w/ 5 speed manual<br />definately a chick magnet, and i havent even started moding yet ;)<br /><a href=\"http://www.cardomain.com/id/chkptcharlie\" target=\"_blank\">www.cardomain.com/id/chkptcharlie</a><br />ok so i\'m a nerd... at least i have a nice car -
I don't know if it has the cross member to attach the airbox to. I have not seen a pre98 engine compartment upclose. It may be impossible to get air up from in front of the radiator too.<a href=\"http://www.onid.orst.edu/~waltejam/\" target=\"_blank\">98 Bright Red Camaro</a><br />Too many mods to list....check my website -
the cross member doesn't have anything to do with the airbox... the fronts are basically setup the same, you need to get the lower airbox, remove the black plastic shroud and it should just slip on, you may have to drill a few holes... bolt it down, and with a little work it should fit just fine... but you will need to go with the 93-98 style lid, because of the angled intake...
merlin2002 Firebird<br />2003 Yamaha YZF 600RComment
-
So my truck is finally getting some work done, after 17 years, Oil pressure sensor went out and it’s located under the lower intake manifold. Have to...10 hours ago -
Hey guys. For starters I’ve always been a big car guy, I love all types of cars and can appreciate all types of engineering. I’ve always been a Chevy...2 weeks ago -
Getting a message saying invalid interface, haven’t used it since last year probably November. First time in 23 years I had a problem. Going to get...2 weeks ago
-
-
need help finding a balancer and a replacement balancer bolt. im at a lost after confusing myself researching.3 weeks ago
Comment