Installation Price on I and S pipes w/ 02 fitting?

[shortdog273]

I'm ready to take off my non-mandrel pipe and replace it with a 2.75" Z28 pipe with 2 45 degree pipes for the "S" pipe. Also the 02 bung or whatever. What's a descent price I should pay to have all of the above installed?? I don't wanna get ripped off.

[arnaldo]

<blockquote>quote:</font><hr>Originally posted by shortdog273:
I'm ready to take off my non-mandrel pipe and replace it with a 2.75" Z28 pipe with 2 45 degree pipes for the "S" pipe. Also the 02 bung or whatever. What's a descent price I should pay to have all of the above installed?? I don't wanna get ripped off.<hr></blockquote>

well, here in cali, for a 3 INCH I pipe installed it cost 150 bucks..i was quoted 200 bucks at one place, and 180 at another..and yes it is mandrel bent..good luck..

[shortdog273]

That's pretty high if they charge you that much just for labor. Anybody else have this custom work done to their car?

[Original 4th Gen V6]

Yes...I have an acetaline torch/welder so I installed my exhaust myself. (Check the sig for exhaust) Spending $200 to cut/weld a few metal pipes is horrible. Especially when you could put $200 towards bigger and better things.

[Shane]

Just got my 3inch dynomax I pipe, Dynomax muffler, muffler pipes, and S pipe put in and they charged me 75 bucks for all that

Sounds alo better then my Flowmaster

[ February 26, 2002: Message edited by: Shane ]</p>

[shortdog273]

Now that's a good deal. Hopefully, I can get a deal like that.

[RacerJ]

Hey shortdog, I think arnaldo was including the price of the I-pipe in there. 3" I-pipe is usually about $100, so his labor was about $50. For just the I-pipe that's a little high.

But for your two bends and the I-pipe it would probably be about $50-60 to just fit them and weld them in. But the new O2 bung will probably be like $50 itself, they're not too cheap on those...

[ February 26, 2002: Message edited by: RacerJ ]</p>