Offset Exhaust Bend

[Guest]

___
___ \___
2in\___
I need to create or achieve a 2 inch offset on a 2 1/2 inch pipe. I dont have access to a welder. Anyone know of a way to do this or a pre bent pipe to accomplish this? Meaning the center of the first pipe needs to be 2 inched away from the center of the second pipe.

[ November 19, 2003: Message edited by: 2KThunder ]</p>

[Clark Griswold]

I guess youre asking about the S-Pipe? If you have AIM, IM me on AgBulit... I am in Houston and have done this to my car, but in three inch.

[Guest]

Actually it is in the itermediate pipe (I think that is what it is called). I am adding a Bullet Muffler to my flowmaster system. The pipe that goes from the cats s-pipe to the muffler is two piece. The piece that goes from s-pipe to the piece over the axle isnt straight.It starts and ends 2 inches off (center too center). To make this I need something to attach to the bullet and make its exit (or entrance) offset by 2 inches.

[hawgs]

You could probably do it with 2 45 degree bends cut and welded together. Also kinda depends on how much room there is front to back though. My s-pipe is made of 2 45 bends welded together then attached to the I pipe, so maybe something like that?


This topic is kinda hard to say exactly what you mean but only typing it out [img]graemlins/rofl.gif[/img]

[Wicked 3800 V6]

Slice a 180 U-bend in the middle of the U, put the slices together turned around, you get what you're looking for. At least, that's what I did. [img]smile.gif[/img]

[hawgs]

180/2=90 90/2=45 ...2 45s might flow a bit better then 2 90s