Flowmaster 40 series

[ReodDai]

Anyone have a pic of this installed on their fbody? Wondering how to curve the pipe since both of the outlets are on the same side. Its dual 2.5" outlet, single 3" inlet.

[Riles]

Both of the outlets should not be on the same side. Measure the side with two holes- one should be your 3 inch inlet, and the other one is the 2.5 out. The one side should only have one hole, and it should be the outlet. Thats how mine is at least.

[ November 25, 2003: Message edited by: Riles ]</p>

[ReodDai]

That would be the 80 series. I know which one is the inlet because one has a big INLET sticker above it and is bigger than the other two =).

[95Batmobile]

I think mine has both outlets on the same side too...
Let me try to get some pics, my car is low tho so they might not show anything lol

[ReodDai]

Basically just need an idea of how the piping would work.

[Devilboy28]

The 40 series is a one-in-one-out design. I have mine mounted where my cat used to be and I had a short dump pipe welded on. Last month or so I had him cut off the dump pipe, run a pipe towards the back of me car and he welded on a "Y" pipe and fabbed up dual chrome tips so it would look better.

[ReodDai]

Well I have the muffler sitting on a table in my living room. Series 40, Center 3" Inlet, Dual 2.5" outlets.

[99BlueSuperSix]

the 40 comes in many configurations. personally i would install it under the body of the car dumping both outlets right before the axle. I had a single outlet flow 40 installed there and it sounded great. Also, be sure to use 3" pipe to the muffler, it will give it a much deeper sound.