Tweet
<blockquote>quote:</font><hr>Originally posted by tonyant21:
nick hows the setup of the b&b? was it hard to install? does it rattle? did u weld anything?<hr></blockquote>
The setup is sweet, love it and would do it again. It was pretty simple just make sure you get it up on a lift to install it -- 45 min job from start to finish. Taking off the old exhaust took the most time to cut it out. It does not rattle i used high temp silicon at all the joints and tightend them down securly. I drove around with it just bolted down for awhile and recently put a few spot welds on it just to be sure it stays. It's a great setup but if you have a 98+ you should use a radiator clamp to tighten it down to keep it swaying from left/right.
nick hows the setup of the b&b? was it hard to install? does it rattle? did u weld anything?<hr></blockquote>
The setup is sweet, love it and would do it again. It was pretty simple just make sure you get it up on a lift to install it -- 45 min job from start to finish. Taking off the old exhaust took the most time to cut it out. It does not rattle i used high temp silicon at all the joints and tightend them down securly. I drove around with it just bolted down for awhile and recently put a few spot welds on it just to be sure it stays. It's a great setup but if you have a 98+ you should use a radiator clamp to tighten it down to keep it swaying from left/right.
Comment