Cat back

[98camaro6er]

Alright this is just a purely hypothetical situation as of now because I have no money to spend on my car right now and I probably wont for a while. But I was just curious as to a couple different setups. I want to get either a spintech or a dynomax exhaust. Are these systems catbacks or are they just mufflers? If Im gonna put a new exhaust on the camaro Im gonna do it right cause Im sick of this ricer crap comin out the back of my car with my Flows. I know a lot of people have Dynomax and have said nothin but good about it. Also I heard that clip of that Fiero and it sounds dang sweet for a 2.8. Im just lookin for a good systen that will give me great performance without haveing to be embarrased that my Camaro sounds like a Civic once I rev it past 3K. Soundclips would be great too!!!

[96 T-Top Bird]

I'm pretty sure u can make a catback from any exhaust.

Go to an exhaust shop (i think most of them have dynomax in stock from what i hear) and they'll just get some exhaust tubbing and run a catback for ya.

Not hard to do. I think someone posted a little bit ago about the dynomax saying it was only gonna cost him like $212 or something to run a cat back from a muffler shop, do a search in the gen tech section.

Also check out some sites so see if dynomax sells a catback, i bet they do, most muffler's sell the catbacks.

I dont have the dynomax, im stuck w/ my flow's also [img]smile.gif[/img] but im happy w/ it, sounds kinda ricey at high rpms, but what are u gonna do [img]smile.gif[/img] ran me less than $300 for the catback system installed.

But ya, dynomax probably has a catback, if not a muffler shop will make u a custom setup.

[Fin]

I've emailed Dynomax about cat-backs for the newer V6 F-bodies, and the response I've gotten says they don't make them. However, you can still get a muffler shop to bend you an I-pipe for your setup. Also, I know that one of our members *COUGH* Bene *COUGH* got a 3" I-pipe from Dynomax to make his system a true 3" cat-back setup. Best bet is to either call around or email whoever has what you're interested in and tell them what you want.

[shortdog273]

Dynomax do make catbacks for 98 and up cars, but they're supppose to be for the V8s. It will still fit on a V6. They're a 3" setup.

[zlightning]

I have a 3inch catback with spintech muffler. The pipes had to be custom bent. Any good exhaust shop should be able to do it for you.

[scottblack]

zlightning how do you like that carsound cat? did it set anything apart from all the rest of them, ie, quality, sound, flow rates, etc.?


scott

[mw02]

I got edelbrock. probably one of the best sounding, right up there with dynomax
[img]graemlins/kitty.gif[/img]