Tweet
Well i just oredered my pacesetter headers and i was just wondering if anybody had any advice on installing them? And what gains were there? and sound...sound alot better? I have a catback magnaflow and SLP CAI any thoughts on sound?
-
96 3.8l green camaro Y87 <br />(Sold January 28th, 2004) New whip (02 Civic SI)<br />\"Out with the bad..in with the good; out with the bad in with the good!\"<br /> <a href=\"http://members.cardomain.com/themeangreen6\" target=\"_blank\">http://members.cardomain.com/themeangreen6</a> -
The install is not that difficult. Take your time don't bust too many knuckles or bolts. Biggest tip I can give is to remove your spark plugs and the little shield near the starter. Good luck. -
theres a review on the mods review section of this website.... thatll give ya most info ya want.
john1998 Silver T-Tops Camaro, 3.8 5 Speed<br />Mods: VFN Fiberglass Stingray Hood, Whisper Lid, Free ram air mod, 3\" I-Pipe to Flowmaster 80 to dual 3\" Hooker dual tips, 160 degree thermo...too much to list <a href=\"http://www.cardomain.com/memberpage/683461\" target=\"_blank\">http://www.cardomain.com/memberpage/683461</a>Comment
-
I can't tell you about the install yet...I am ordering mine a week from today (payday)! I am pupped, because a friend of mine sells pacesetter stuff, and is giving them to me at his cost...$325 with y-pipe, ceramic coated!<a href=\"http://www.fullthrottlev6.com\" target=\"_blank\">www.fullthrottlev6.com</a> THE SOURCE!Comment
-
well arent you the lucky one...i dont think it will be that hard of an install...just the fact off taking everything off and working under the car and what not...its just going to be tedious96 3.8l green camaro Y87 <br />(Sold January 28th, 2004) New whip (02 Civic SI)<br />\"Out with the bad..in with the good; out with the bad in with the good!\"<br /> <a href=\"http://members.cardomain.com/themeangreen6\" target=\"_blank\">http://members.cardomain.com/themeangreen6</a>Comment
-
Took half the time to install as it did to remove the manifolds...I can easily reach all bolts but one from the top of the car with my wrench.<a href=\"http://www.onid.orst.edu/~waltejam/\" target=\"_blank\">98 Bright Red Camaro</a><br />Too many mods to list....check my websiteComment
-
So my truck is finally getting some work done, after 17 years, Oil pressure sensor went out and it’s located under the lower intake manifold. Have to...1 week ago -
Hey guys. For starters I’ve always been a big car guy, I love all types of cars and can appreciate all types of engineering. I’ve always been a Chevy...3 weeks ago -
Getting a message saying invalid interface, haven’t used it since last year probably November. First time in 23 years I had a problem. Going to get...4 weeks ago
Comment