Tweet
hey i got my tubular manifolds from the 00+ v6s in the mail the other day and i'm looking into porting them. what are your thoughts to the amount of money this would be worth? if machine shop says "sure, we'll do it for 40 bucks" then that would be worth it, right? i'm not going to go out and buy headers so i wan't to get the most i can out of these manifolds.
-
-
I ported mine with a dremel. It was free so I would say it is worth it. You do need to have a little understanding of fluid flow. Don't take the bore as big of a hole as possible approach. I am not familiar with those manifolds. So I don't know how much can be gained.
My manifolds had alot of room for improvement.
DEE1997 GTP(13.3@104)-Sold<br />1999 Trans Am M6 -
The easiest way is to port match the primaries to the manifold gasket, it will give you some gain.
Tom<a href=\"http://www.fullthrottlev6.com\" target=\"_blank\">www.fullthrottlev6.com</a><br /><a href=\"http://www.chitownracing.com\" target=\"_blank\">www.chitownracing.com</a>Comment
-
So my truck is finally getting some work done, after 17 years, Oil pressure sensor went out and it’s located under the lower intake manifold. Have to...1 week ago -
Hey guys. For starters I’ve always been a big car guy, I love all types of cars and can appreciate all types of engineering. I’ve always been a Chevy...3 weeks ago -
Getting a message saying invalid interface, haven’t used it since last year probably November. First time in 23 years I had a problem. Going to get...4 weeks ago
Comment