zzp egr block off question..

[vr4gasm]

on their block off plates.. is there something on the plate that fits inside the stock exhaust manifold? i had some made but they are smooth top and bottom side and i fired up the car... tick tick tick... exhaust leak so i torqued it down more and of course when you tighten it up it wants to rotate with the bolt but i got it to stay in place with some vise grips.. but i am still leains out some air there i do have a metal exhast gasket between the manifold and the plate.. i just need to know if theres actually seals it off or is it smooth on both sides too?

[Meatyshells]

Re: zzp egr block off question..

just use some cooper rtv or something to seal it

[ssms5411]

Re: zzp egr block off question..

just use some cooper rtv or something to seal it

^ Copper RTV is your friend on the block off for the header.

[ssms5411]

Re: zzp egr block off question..

The one on the upper manifold should seal without using any RTV.

[vr4gasm]

Re: zzp egr block off question..

intake sealed fine i used some copper rtv spray i will get a tube of the thicker stuff and see how it goes..

[97rs4life]

Re: zzp egr block off question..

there's is just a flat piece of metal, nothing that goes into the manifold. Yes it will want to rotate. I run the plate on my headers right now

[kristen]

Re: zzp egr block off question..

yea little rtv makes you golden

[steddy]

Re: zzp egr block off question..

intake sealed fine i used some copper rtv spray i will get a tube of the thicker stuff and see how it goes..

I was wondering if there was any noticeable difference with removing the EGR, rather than having it (mine's on it's way)?

[nascar24jd]

Re: zzp egr block off question..

Will the ZZP block off work on the 3.4 or only the 3.8?