Tweet
kit #5175 is their anything i should look out for when hooking up? how hard is to hook up my my self?
-
94 firebird black 3.4 A4<br />ram-air hood,trans am nose,30th aniversery raceing stripes/side,decals,tb-bypass,160* thermostate,ported throttle body,accel coils,msd wires,NGK plugs,catback-flowmaster exhaust,ASP underdrive pulley\'s,k&n cone airfilter,aluminum race pedals,N.O.S 5175,trans go shift kit,corvette servo,converted to a 96 rear with 3.42\'s,lsd,disk brakes,mac lowering springs, Xenon headlights,chrome firehawk 17\'s with 275/40/17<br />best et. 15.558<br />mph 87.89 -
Woo hoo, another nitrous person :D
Did you get a fuel pressure safety switch?
Also before you juice it for the first time open the bottle to get any crap out of the braided line before you have it mounted where the spray would go into the throttle body.
I didn't install mine myself because I can't wire anything together [img]graemlins/crybaby.gif[/img]Race car - gone but not forgotten - 1997 firebird V6
nitrous et & mph: 12.168 & 110.95 mph, n/a 13.746 & 96.38 mph
2013 Dodge Challenger SRT8: 12.125, 116.45
2010 Ford Taurus SHO: no times yet -
It's extremely easy to hook up if you can follow the instructions. I suggest you lay everything out in the car where you want to mount it and make sure all your lines are of the right length, etc..
Don't fill the bottle till after it's all mounted, disconnect the negative side of your battery, and take your time.
Also, once installed start witht he small jets to get use to it a few times then move up.94 Quasar Blue Z28<br /><a href=\"http://www.9t4z28.com\" target=\"_blank\">http://www.9t4z28.com</a><br /><a href=\"http://www.9t4z28.com/Dyno1.htm\" target=\"_blank\">http://www.9t4z28.com/Dyno1.htm</a>Comment
-
definitly start small. Take your time and just do like the instructions say. Got any other ?'s just post or email folks.Andy Adamez<br />--------------------<br />3.8L 97 V6<br />Hurst Shifter w/ Home Made Handle, Hypertech 160 Thermo, Ported MAF, 5 Point Harness for Pass & Driver, Painted Valve Covers, Nitrous Express Wet EFI KitComment
-
So my truck is finally getting some work done, after 17 years, Oil pressure sensor went out and it’s located under the lower intake manifold. Have to...20 hours ago -
Hey guys. For starters I’ve always been a big car guy, I love all types of cars and can appreciate all types of engineering. I’ve always been a Chevy...2 weeks ago -
Getting a message saying invalid interface, haven’t used it since last year probably November. First time in 23 years I had a problem. Going to get...2 weeks ago
-
-
need help finding a balancer and a replacement balancer bolt. im at a lost after confusing myself researching.3 weeks ago
Comment