All you backseat Juicers! - FirebirdV6.com/CamaroV6.com Message Board

Announcement

Collapse
No announcement yet.

All you backseat Juicers!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • All you backseat Juicers!

    Question for anyone who has the bottle in the back seat. Where did you run your n2o line out? What about the Blow down tube?
    I have missed too many races because the bottle was closed and in the trunk!
    Thanks. [img]graemlins/thumbsup.gif[/img]
    1997 Chevrolet Camaro v6 - 13.8@104MPH
    1997 Dodge Viper GTS

  • #2
    I run the line through the little panel by the edge of the doorwhere that little pannel is held on by like 6 screws and then up through the firewall hole. I will try to take some pics today later
    <b><a href=\"http://www.sick-sixx.com\" target=\"_blank\">SICK-SIXX MEMBER</a></b><br />NA 14.345 with a 1.863 60 foot<br />Nitrous 13.03@99.5 with a 1.63 60 foot<br /><br />2000 Camaro 3.8L A4: USE TO HAVE Comp Cam 210/220 .535/.547 113lsa 111 I/C, Port and Polished Heads, NX Wet Kit 100 Shot, CPRA made by CP, RK Sport Headers

    Comment


    • #3
      yea i have my bottle mounted in between the back seats and i have the fedline going under the carpet and through the firewall. it looks very trick. if i had a digtital camera i would snap some photo

      Comment


      • #4
        I had my bottle mounted in the driver side rear seat. I ran the line under the carpet and out the drain plug right behind the driver's seat. Then I followed the fuel lines up to the engine bay.
        -<i>Travis</i><br /><b>99 Trans Am, Pewter, A4</b> Forged, stalled, and cammed<br /><b>85 Buick Regal WH1 T-Type</b> It\'d be cool if it ran...<br /><b>94 Camaro 3.4, Teal, M5</b> The daily beater

        Comment


        • #5
          SO theres a drain plug behind the drivers seat under the carpet? Cool I will use that. I am currently using a hole on top of the rear deck, but I am moving the bottle to free up some of the nitrous line so I can get my solenoids away from my exhaust manifolds.
          96Beast - Still selling the wet kit stuff??
          Thx.

          EDIT - What about Blow Down Tubes???

          [ December 18, 2002: Message edited by: AZ3.8Camaro ]</p>
          1997 Chevrolet Camaro v6 - 13.8@104MPH
          1997 Dodge Viper GTS

          Comment


          • #6
            I just sticm mine under the seat so it looks like it is exiting the car.
            <b><a href=\"http://www.sick-sixx.com\" target=\"_blank\">SICK-SIXX MEMBER</a></b><br />NA 14.345 with a 1.863 60 foot<br />Nitrous 13.03@99.5 with a 1.63 60 foot<br /><br />2000 Camaro 3.8L A4: USE TO HAVE Comp Cam 210/220 .535/.547 113lsa 111 I/C, Port and Polished Heads, NX Wet Kit 100 Shot, CPRA made by CP, RK Sport Headers

            Comment


            • #7
              In my sig you can see the set up
              Just in front of the bottle set up in the floor there is a rubber grommet as a drain plug.
              I yanked that and ran my braided line out this hole towards the engine.
              As for the blow down tube, same place.

              http://www.angelfire.com/nj3/misterjuice/james.htm
              Page one shows my set up and you can see the blow down tube going towards the floor

              http://www.angelfire.com/nj3/misterjuice/james4.html
              This is the underside of the grommet. All my wires, braided line and blow down tube exit here

              [ December 18, 2002: Message edited by: 12secondv6 ]</p>
              Race car - gone but not forgotten - 1997 firebird V6
              nitrous et & mph: 12.168 & 110.95 mph, n/a 13.746 & 96.38 mph
              2013 Dodge Challenger SRT8: 12.125, 116.45
              2010 Ford Taurus SHO: no times yet

              Comment

              Latest Topics

              Collapse

              There are no results that meet this criteria.

              FORUM SPONSORS

              Collapse
              Working...
              X