need alittle purge help........dual question already searched

[IThinkImFast]

ok,
im now starting to do dual purge plumming....i went out and bought a "brass tite" compression T. im just going to run a braided hose from the purge noid to the tee then two pieces of steel or copper...whichever i can find....from the two ends of the tee to the base of the windsheild....sound right? the comprettion tee works like this right...i install the copper/steel pipe...put that little metal bead thing over the pipe and into the tee....then put the tee nut thing over the pipe and bead thing and tighten down as much as i can right? then the metal bead thing will compress down and catch the pipe and hold it in?

[Arctc Wolf]

i'd think a y-connector would be better, but yea. if u have a firebird, try putting the purges in ur vents on the side.

[Skinny]

Yes, I used the same type of T fitting in mine. "As tight as you can" probably isn't a good idea, but it needs to be tight. ;)

[andrew N.]

Where the hell do you get more copper pipes or anything to route to outlet??????????

I went to Home Depot and Pep Boys, and they had nothing close to the same size as what comes with the kit.

[andrew N.]

Where the hell do you get more copper pipes or anything to route to outlet??????????

I went to Home Depot and Pep Boys, and they had nothing close to the same size as what comes with the kit.

[Skinny]

<blockquote>quote:</font><hr>Originally posted by andrew N.:
Where the hell do you get more copper pipes or anything to route to outlet??????????

I went to Home Depot and Pep Boys, and they had nothing close to the same size as what comes with the kit.<hr></blockquote>

Check at a hobby shop.