Tweet
sup,
like i said in a previous post i crushed the threads on my NX shark nozzel while tring the screw the thing into the TB. anyways i ran a few times with it....should i get a new one? could the passages inside be messed up? if the internals are ok i am in no rush to get a new one. its tapped into the TB nicley. its alittle high cause its screwed in by like the last few threads and its about 2 to 3 inches from the Throttle plate. so does everything seem good?
also i have some JB weld holding it in also. are you suposed to JB weld then screw t in or put it in then JB weld?
like i said in a previous post i crushed the threads on my NX shark nozzel while tring the screw the thing into the TB. anyways i ran a few times with it....should i get a new one? could the passages inside be messed up? if the internals are ok i am in no rush to get a new one. its tapped into the TB nicley. its alittle high cause its screwed in by like the last few threads and its about 2 to 3 inches from the Throttle plate. so does everything seem good?
also i have some JB weld holding it in also. are you suposed to JB weld then screw t in or put it in then JB weld?
Comment