12SECV6!! nozzel placement mater by an inch or so? make a diffenence in HP/TQ?

[IThinkImFast]

hey,
i want to finalize the install and clean it up. I have the nozzel place 2 to 3 inches from the TB plate. Its alittle further then most i have seen but the TB plate clears it fine. so is it good here? its like alittle past that hole inside the TB on the passengers side. AKO? or should i move it? and if i were to move it should i JB weld the pervious hole? i think its ok where it is.

[Shirl]

Sounds like a good spot! That's where mine is. If you decide to move it, though, just use a plug for the hole in case you change your mind and put it back in that spot.

[IThinkImFast]

cool thanks Shirl!!!!

[malice10985]

I used to have my nozzle really close to the MAF like that. I made the fuel map act funny whenever I sprayed.

I have my nozzle right after the airbox now, really far from the MAF. It is much more predictable.

[IThinkImFast]

i have a wet kit so it has to be after the MAF. i measured the nosel from the inside of the TB and i measured that its about 1.25 to 1.5 inches from the TB plate. so its pretty far in there. its like an inch past the MAF.

[12secondv6]

As long as it is after the maf then you should be fine.

Check my sig for pic's of mine