Wiring

[RadRacer]

Just checking your guy's opinions. If all goes as planned, wiring/switch panel should begin tomorrow :)

[ssms5411]

Re: Wiring

Good luck with the wiring, I can't understand the above.^ I would look at Holleys website for the wetshot wiring diagram.

[ssms5411]

Re: Wiring

For the window switch you need a power, ground , ref. wire signal, and the ground out wire to activate the nitrous solenoid.

[RadRacer]

Re: Wiring

I have a power and ground (ran through the relay) and wire out ground to the noids. I didn't put the tach signal, but I know where to go with it.

[ssms5411]

Re: Wiring

I would watch how much you run through the relay, it might just take a dump on you. I just used 2 relays so I wouldn't overstress just the one.

[RadRacer]

Re: Wiring

I'll be using 3 relays: one to turn on the WS, one to activate the nitrous and fuel noids, and one to active the purge noid. If I get a heater, it will be run by a 4th relay. I'm a big fan of relays :)

[ssms5411]

Re: Wiring

That is good.