New to tuning need help

[01PewterDropTop]

I just got my tuner and i am about to go plug it in. How do i disable the torque management? i cant find the how to anymore. Also i have the GT2 Cam, ported intakes, and Headers with true duels.

[01PewterDropTop]

Re: New to tuning need help

Ok so i hooked my tuner up. and i cant figure it out it didnt come with any instructions. i got the scanner part to work now how do i edit and tune? i open the editor portion and it has nothing in it. do i have to save and load something?

[01PewterDropTop]

Re: New to tuning need help

I figured out how to read the VCM, but when its done it prompts me to save the .bin file I click save and nothing happens the file does not save and the menu does not go away.

[01PewterDropTop]

Re: New to tuning need help

Ok so i figured out how to save the file it comes up as *.bin and you have to delet the *

[01PewterDropTop]

Re: New to tuning need help

I am also tring to disable the p0300 code for my cam andf the post cat O2 codes couse i dont have cats. is this correct i select edit, engine, DTCs, select the code, select no error reported, and SES enabled off??

[01PewterDropTop]

Re: New to tuning need help

slowely but surely.

[bigbrian442]

Re: New to tuning need help

have you look on the HPtuners board? All this is there.

[LETZRIDE]

Re: New to tuning need help

http://forum.camarov6.com/showthread...tuners+dummies

That's help begin to explain functions...it's far from done though...