Tweet
Hello, so I changed the front bearings on the bird and the ABS inoperative light came on. I made a mistake of not removing negative battery cable. Now do I turn this off. I tried removing both cables from the battery and it didn't work. Would a regular scanner work?
-
-
Are the abs wires all secure ?08' L76 6.0L 4X4 Chevy EXT.Cab LTZ Vortec MAX with Snug top cover, Dynomax exhaust,Hptuners& K&N intake
96' Camaro M5 to A4 conversion, alot of mods . GT35R Turbo full suspension. Built engine -
I believe so. I think there's only one that I unplugged.Comment
-
I just cycle it turn the key to the on position but don’t start it until the full pump primes then start. If it is still on then you have a sensor out or one of the wires is not secure. You only did one wheel bearing? Usually I’ll do both at the same time.08' L76 6.0L 4X4 Chevy EXT.Cab LTZ Vortec MAX with Snug top cover, Dynomax exhaust,Hptuners& K&N intake
96' Camaro M5 to A4 conversion, alot of mods . GT35R Turbo full suspension. Built engineComment
-
I still have trouble with mine, every other start the ABS light comes on, I’ve done the wheel bearings and the sensor on the rear differential. So I just live with it.08' L76 6.0L 4X4 Chevy EXT.Cab LTZ Vortec MAX with Snug top cover, Dynomax exhaust,Hptuners& K&N intake
96' Camaro M5 to A4 conversion, alot of mods . GT35R Turbo full suspension. Built engineComment
-
Just one. I'll double check again this weekend. Thanks Steve.Comment
Comment