Tweet
Re: Very Loud Engine Noise. Help Please!
How are they going to go about doing 11:1 CR? Flat top pistons or milling the heads or both? You don't want to mill these heads too much without running good MLS gaskets and ARP head studs. There isn't a whole lot of meat there to remove lol!
11:1 is still within the "safe" range. I think max is around 11.5 for pumpgas unless you angle mill the heads and all that fun stuff.
If the shop you're taking it to knows their stuff, then I'm willing to bet it won't be cheap but should be a reliable build. You will need to invest in getting it tuned by a good shop or somebody that knows what they're doing. That high compression doesn't allow much wiggle room.
How are they going to go about doing 11:1 CR? Flat top pistons or milling the heads or both? You don't want to mill these heads too much without running good MLS gaskets and ARP head studs. There isn't a whole lot of meat there to remove lol!
11:1 is still within the "safe" range. I think max is around 11.5 for pumpgas unless you angle mill the heads and all that fun stuff.
If the shop you're taking it to knows their stuff, then I'm willing to bet it won't be cheap but should be a reliable build. You will need to invest in getting it tuned by a good shop or somebody that knows what they're doing. That high compression doesn't allow much wiggle room.
Comment